ATR Leveling System – T Spacers – 3mm – 3UT

Floors and Walls

T Spacers 3mm

For use with brick pattern, subway layout, herringbone, etc.

Apex Coverage Area – 100 Pieces of tile compare at 33 pieces of tile with other leveling system

Tiling made easy with the ATR Tile Leveling System

T spacer 1/8″ (3mm) – Tile thickness 15/64 – 51/64 (1/4 – 3/4) (6mm-20mm)

You only need 1 cross spacing plate for 4 tiles NOT 4 Clips like every other Leveling System

While every other system require 376 units for 100 pieces of tile ATR require only 117

Very easy to learn and use at any skill level

Advantages of the ATR Tile Leveling System

• No Tools (GUN) needed! No need for expensive hand tools.
• Simple and quick to lay with only 2 elements: Spacer & Spindle.
• The only system that removed without the use of a force
• Only System that leave clean grout line (no risk of spacers not break all the way)
• Cross Spacers (+) Shape allow for 2/3 of saving
• Creates a lippage free surface
• Keeps tiles in place while drying
• All-in-one grout spacing and tile alignment system
• Stress free installation
• Professional finishes every time
• Very simple and easy to use
• Saves time
• Suitable for floors and walls
• Suitable for indoor and outdoor uses
• Re-usable spindle
• Australian design and Australian made

Example of the different between ATR to other leveling system

100 pieces of tile project ATR use total of 117 spacers with approximately cost of $29.99 compare to any other leveling system 376 spacers with cost of $44.00

About 33% saving in money of spacers and over 66% time saving in Labor of saving on installing additional 259 pieces

How to use 5 Easy steps

1. Spread thinset install tile

2. Screw spindle into spacing plate, Slide spindle with spacing plate attached in between two tiles.

3. Tighten spindle clock wise firmly until all four corners are aligned flush.
* Remove Re-usable spindle once tile adhesive is dry.